RL78/G24 Fast Prototyping Board
7.2
Using COM Port Debugging with CS+
Figure 7-2 and Figure 7-3 show the settings of CS+ when it is to be connected to the RL78/G24 Fast
Prototyping Board.
[Using Debug Tool]:
•
Select [RL78 COM Port] from [Using Debug Tool] in the [Debug] menu.
[Connection with Target Board]:
•
[Communication port]: Select the COM port number for assignment to the RL78/G24 FPB from the pull-
down list.
[Reset control pin]: Select [DTR].
For details and points for caution, refer to the following application note for the RL78 COM port debug tool.
RL78 Debugging Functions Using the Serial Port (R20AN0632)
•
R20UT5091EJ0100 Rev. 1.00
Apr.16.23
Figure 7-2 Panel for Selecting the Debug Tool
Figure 7-3 [Connect Settings] Tabbed Page of CS+
7. Developing Code
Page 35 of 36