BMW S 1000 XR 2023 Rider's Manual page 182

176 MAINTENANCE
Radial brake calipers on
the axle adapter
M10 x 65
28 lb/ft (38 Nm)
Insert the wheel speed sensor
cable into the holding clips 1
and 2.
Insert the wheel speed sensor
into the drilled hole and install
screw 3.
Wheel speed sensor on
forkleg
M6 x 16
Thread-locking compound:
micro-encapsulated
6 lb/ft (8 Nm)
WARNING
Brake pads do not contact
the brake disc
Risk of accident due to de-
layed braking effect.
Before driving off, check
that the braking effect kicks
in without any delay.
Engage the brakes repeatedly
until the brake pads make
contact with the discs.
Remove adhesive tape from
wheel rim.
Remove front wheel stand
and auxiliary stand.
Removing the rear wheel
Raise motorcycle, preferably
using a BMW Motorrad rear-
wheel stand.
Mount the rear-wheel stand.
( 160)
Support the rear wheel, e.g.
with a wooden block, so that
it cannot fall down after the
quick-release axle is removed.
Press the brake caliper 1
against the brake disk 2.
Brake pistons are pressed
back.
Remove the axle nut 1 with
washer.
Loosen the lock nuts 2 on the
left and right.