Adjustments - KNOVA KN SCM-07A Manual

ASSEMBLY
10. Open the pulley cover, install the key and motor pulley
to motor shaft.
Install the worm gear pulley on the shaft closest
to the gear box.
Use a straightedge to check the alignment of the pulley
wheels, and adjust them as needed.
When the pulley wheels are aligned, tighten the set
screws on both pulleys and install the V belt

ADJUSTMENTS

WARNING
: Turn off the machine and disconnect
from the power supply before doing any adjustment.
1. VISE ADJUSTMENT
To use the vise:
• Loosen the two hex bolts.
• Use the scale as a guide to set your angle.
• Tighten the hex bolts.
• Loosen the hex bolt on the opposite jaw so the jaw
can float, then match the angle of the workpiece
and retighten the hex bolt.
• Tighten the vise against the workpiece.
The belt tension can be adjusted by adjusting
the motor lock bolt.
Set
screw
screw
11. Install the work stop shaft into the side of the band saw
then lock it in place by tightening the set screw. Slide
the work stop onto the end of the shaft and lock it
into position with the set screw
Hex
bolt
Hex
bolt
5
Set
Scale
Motor
lock bolt
Work
stop