Specific Safety Instructions The Machine; Electrical Requirements - KNOVA KN SCM-07A Manual

GENERAL SAFETY INSTRUCTIONS
16. NEVER LEAVE TOOL RUNNING UNATTENDED.
TURN POWER "OFF". Don't leave tool until it comes
to a complete stop.
17. DON'T OVERREACH. Keep proper footing and
balance at all times.
18. MAINTAIN TOOLS WITH CARE. Keep tools sharp
and clean for best and safest performance. Follow
instructions for lubricating and changing accessories.
19. DO NOT use power tools in the presence of
flammable liquids or gases.
20. NEVER REMOVE GUARD, SAFETY DIVICES
OR ART OF THE MACHINE.
SPECIFIC SAFETY INSTRUCTIONS FOR THE MACHINE
1. Secure the machine to floor before operating.
2. The machine must be switched off before inserting
material to be cut in the vice or before removing
material to be cut from the vice.
3. Keep your hands and fingers in a safe distance from
the running saw blade at all times.

ELECTRICAL REQUIREMENTS

POWER SUPPLY AND MOTOR SPECIFICATIONS
WARNING
To avoid electrical hazards, fire hazards,
:
or damage to the tool, use proper circuit protection.
Use a separate electrical circuit for your tools. To avoid shock
or fire, if power cord is worn or cut, or damaged in any way,
have it replaced immediately.
GROUNDING INSTRUCTIONS
WARNING
This tool must be grounded while in use
:
to protect the operator from electrical shock.
IN THE EVENT OF A MALFUNCTION OR BREAKDOWN,
grounding provides a path of least resistance for electric
current and reduces the risk of electric shock. This tool is
equipped with an electric cord that has an
equipment-grounding conductor and a grounding plug.
The plug MUST be plugged into a matching receptacle that
is properly installed and grounded in accordance with ALL
local codes and ordinances.
DO NOT MODIFY THE PLUG PROVIDED. If it will not fit
the receptacle, have the proper receptacle installed by a
qualified electrician.
IMPROPER CONNECTION of the equipment-grounding
conductor can result in risk of electric shock. The conductor
with green insulation (with or without yellow stripes) is
the equipment-grounding conductor. If repair or replacement
of the electric cord or plug is necessary, DO NOT connects
the equipment-grounding conductor to a live terminal.
CHECK with a qualified electrician or service person if you
do not completely understand the grounding instructions,
or if you are not sure the tool is properly grounded.
21. BE CAREFUL. Pay attention to what you are doing.
Work reasonably. Do not use the machine when
you are tired.
22. HAVE YOUR MACHINE REPAIRED BY AN EXPERT
ONLY! This machine meets the applicable safety
provisions. Any repairs may only be executed by an
expert, using original spare parts; otherwise, the user
could face a risk of injury.
23. Children and persons not familiarised with the machine
and persons with limited physical, sensory and mental
skills must not use the machine.
4. The saw blade must not be broken by hand.
5. Safety equipment and guards, etc, must not be removed.
6. Never remove the cutting chips by hand. Use a brush
at all times.
7. Never leave the machine when in operation.
Refer to nether picture:
WARNING
: Improper connection of equipment
grounding conductor can result in the risk of electrical
shock. Equipment should be grounded while in use to protect
operator from electrical shock.
WARNING
: This machine is for indoor use only.
Do not expose to rain or use in damp locations.
GUIDELINES FOR EXTENSION CORDS
USE PROPER EXTENSION CORD. Make sure your
extension cord is in good condition. When using an extension
cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause
a drop in line voltage, resulting in loss of power and cause
overheating.
Be sure your extension cord is properly wired and in good
condition. Always replace a damaged extension cord or have
it repaired by a qualified person before using it. Protect
your extension cords from sharp objects, excessive heat and
damp or wet areas.
2
3-Prong plug
Grounding prong
Properly
grounded outlet