Operation; Settings - Compak i3 PRO User Manual

9.

OPERATION

9.1. MAIN SWITCH
The main switch (
positions:
I / 0 / II (Fig. 7)
The equipment's electronic
functions are activated
Equipment off
Equipment in manual mode.
Backup system that allows the
equipment to be used in the
event of a fault in the power
board or keypad. When in
manual mode, the equipment
starts grinding until the switch is
set to OFF.
K09639H01 | PROC-CAL/002/03 USER MANUAL | V. 27/09/2023
) has the following
i3 PRO
I
O
II
Fig. 7
10.

SETTINGS

10.1. DISPLAY ICON GUIDE
*
*
10.2. UTILIZATION
A pre-programmed single or double can be
set by simple pressing the corresponding
icon on the LCD screen.
The preselection of a single or double dose
will remain active until it is changed by
pressing one of the two numbered preselect
icons. This preselection is reflected on the
LCD screen with the icon of the active
selection in the secondary color, and the rest
of the icons in the principle color.
Dispensing the preselected dose by pressing
the lower pulse button (
the grinding cycle begins, a timer countdown
will begin on the LCD screen, which will
count down the timed dose cycle to zero.
10.3. GRIND TIME CONFIGURATIONS
To set up dose time, simultaneously press the
number of the desired dose to be configured
and the Grind button 2 seconds until it blinks.
Pressing to decrease or to increase the time
until get the desired, to confirm press the
Grind Button.
*
) one time. When
13