Cleaning - Compak i3 PRO User Manual

11.

CLEANING

11.1. GENERAL CLEANING
11.1.1 To ensure that the grinder functions
properly, and produces the highest quality
grind possible, the parts that come into
contact with coffee
periodically.
General Cleaning guidelines as follows:
•
Always turn the main power switch to
the off position (
•
Unplug the machine from the power
source.
•
Do not submerge the grinder in water
or use power washing devices.
•
The appliance is not to be cleaned with
a water jet.
11.2. BEAN HOPPER CLEANING
11.2.1 In order to properly clean the bean
hopper ( ), first empty out all remaining
beans and fragments.
To remove the hopper, first close the bean
trap ( ), and then loosen the hopper lock
screw ( ) and lift the hopper straight up.
Clean the hopper ( ) with a moist soft cloth
or with a small amount of water and neutral
soap to eliminate any oily residue from the
beans.
Replace the bean hopper (
same steps as the removal process, but in
reverse.
14
should cleaned
).
) following the
K09639H01 | PROC-CAL/002/03 USER MANUAL | V. 27/09/2023
11.3. CLEANING THE GRIND CHAMBER
11.3.1 It is recommended that the grind
chamber be cleaned monthly with a
cleaner . This process will eliminate smelly
residues from the coffee remains, which can
negatively affect the quality of the brewed
coffee.
Care is needed when handling cutting burrs
during cleaning
The steps to follow are:
In order to properly clean the bean hopper
( ), first empty out all remaining beans and
fragments.
•
Close the bean trap on the hopper (
) and grind out the remaining coffee in
the grind chamber.
•
Pour the recommended
cleaning product into the bean hopper
( ) and open the bean trap (
allowing the cleaning product to pass
into the grind chamber.
•
Grind the cleaning product at a
medium coarse grind setting until
the recommended amount is passed
through the system and nothing
remains in the grind chamber.
•
Clean the hopper (
coffee beans.
•
Discard the first 2-3 doses of coffee to
assure that the residual cleaning product is
removed from the grind chamber and set the
grind regulator to the desired setting ( ).
•
Following these steps will ensure that
the grinder is clean and ready for use.
•
We do not recommend the taking apart
of the grind assembly unless changing
burrs, or removing
obstruction in the grind chamber.
Removal of the grind assembly should
be performed by a qualified service
technician.
grinder
),
) and refill with
a blockage/