Nilfisk-Advance MH 7P Instructions For Use Manual page 16

english 7.2.3 Checking the pump oil
quality
7.2.4 Changing the pump oil
MH 7
7.2.5 Emptying the fuel oil
tank
7.2.6 Flame sensor
14
A
A
MH 5 / 8
1. Check color of pump oil.
If the oil has a grey or white
shade, change the oil (see
chapter 7.2.4)
2. Top off oil level with fresh oil
if necessary.
Oil type see chapter 9.3 Tech-
nical Data.
1. Unscrew the oil drain plug (A)
and drain oil into a suitable
container.
2. Check that the drain plug
gasket is in place and reinstall
drain plug.
3. Fill pump with proper grade
and amount of oil.
Oil grade and capacity see
chapter '9.3 Technical Data'.
1. Prepare a container which
is capable of containing the
amount of fuel remaining in
the tank.
2. Place drain channel beneath
the drain plug.
3. Remove the drain plug and
drain the fuel into the pre-
pared container carefully not
to spill fuel oil.
4. Check that the drain plug
gasket is in place and reinstall
drain plug.
5. Check tank and plug for
leaks.
1. Remove the sensor and clean
with a soft cloth.
2. Confirm that the sensor is
correctly seated when rein-
stalling.
1) Options / model variants
Original instruction