Wired Network Setup (Applicable To Wired Network Models); Set Ip Address; Automatic Setting; Manual Setting - Pantum PT14C1A Series User Manual

04
Wired network setup (applicable to wired
network models)
In case printers support wired network printing, they can be connected to network to control printer
to print in wired network mode.

Set IP Address

The IP address of the printer may be automatically obtained through DHCP function or set
manually.

Automatic Setting

DHCP automatic setting function is enabled by default on the printer.
1.Connect the printer to the network through a network cable and complete the startup preparation
work.
2. The printer will receive the IP address assigned by server automatically. It may take server
minutes to receive IP address under the influence of network environment.
You can check the IP address of printer by printing "Network setup page" out,or check network
information by viewing the control panel of printer. If the IP address is not listed, please check
network environment and then try again after waiting for several minutes.
Note: If DHCP server fails to assign IP address automatically, the printer will get the link-local address
•
assigned by printer automatically: 169.254.xxx.xxx.

Manual Setting

To set up IP address for printer through the control panel of printer manually.
To set up IP address for printer through the embedded Web server manually.
16