802CN/802-II
Users Manual
To set the sensitivity for the external sensor:
1. Turn on the Product while pushing at the same
time.
The screen shows the model number and software
version number.
2. Push again to enter the sensitivity setting.
The screen below shows that the initial value is 10.00,
which means 10.00 mV/m/s².
10
You must set the sensitivity in mV/m/s² units.
3. Push () or () to enter setting mode. 10.00
flashes.
4. In setting mode (when the reading flashes), push to
increase 0.01, or push to decrease 0.01. The unit is
mV/m/s².
5. When you get the required sensitivity, push to
save the setting and exit setting mode.
The external sensor can be purchased separately.
Set the sensitivity according to the reference data
that is shipped with the external sensor.
Note
Note