Removing The Flanged Immersion Heater; Removing The Protective Anode; Fitting The Protective Anode; Descaling - STIEBEL ELTRON PSH 15 mini ID Operation And Installation Manual

INSTALLATION

SPECIFICATION

15.3 Removing the flanged immersion heater

15.4 Removing the protective anode

15.5 Fitting the protective anode

» To include the steel cylinder in the earthing mass, follow the
order of installation of the fixing elements of the protective
anode, see chapter "Removing the protective anode".

15.6 Descaling

» Remove the flanged immersion heater.
» Carefully tap the immersion heater element to remove larger
limescale deposits and immerse the heating element up to
the flange plate in descaling agent. Never treat the cylinder
surface or the protective anode with descaling agents.

15.7 Checking the protective anode

» Check the protective anode for the first time 2 years after
installation. For this, remove the flanged immersion heater;
see chapter "Removing the flanged immersion heater and
protective anode". Replace worn protective anodes.
» Afterwards determine the time intervals at which further
checks should be carried out.

15.8 Replace power cable

» The power cable must be replaced by a qualified electrician
with the original spare part (part no. 286211).
» Never remove the plastic thread holding the profile plate.

15.9 Temperature controller/limiter sensor

When replacing or removing the temperature controller/limiter,
reinsert the sensors into the protective pipe in accordance with
the following diagrams.
200
270
8 |PSH MINI ID
16. Specification

16.1 Dimensions and connections

100
3
200
316
1
1 Hot water connection (red)
2 Cold water connection (blue)
3 Mounting bracket

16.2 Wiring diagram

1/N/PE ~ 220 V / 230 V
1 Protective anode
2 Resistance 560 Ω
70
296
2
2
1
L N
L N PE
WWW.STIEBEL-ELTRON.COM