Acekare YOMPER+ User Manual page 22

Failure
The Yomper stalls
The Yomper does not stop
Solution
This can happen if the slope is too steep, or the chair is too heavy,
or if wheelchair tires are deflated. You may have to manually
assist the Yomper or adjust speeds when travelling up a steep
slope. This is a safety measure to avoid engine overheating.
When your battery is low (<20%), it can also happen that the
Yomper «stalls» during intense effort. After a few seconds you
will be able to set-off again. We recommend that you assist the
Yomper on steep slopes. You will be able to use the Yomper
without assist on flatter surfaces.
We recommend that you recharge your battery.
If you have many routes requiring constant effort from the
Yomper, or in case of heavy user weight, we recommend the
optional battery (higher amp-hours) which will be more efficient
over time.
In indoor mode (green LED), too much resistance stops the
motor (similar to using your hands to brake via the handrails).
Switch to outdoor mode or increase the resistance.
In indoor mode, this can happen if the resistance level is set too
high.
In the parameter setting, reduce the resistance
If pressing the main button on EasyGo does not turn off Drive
unit power, switch off the Yomper and the EasyGo controller
box and contact your dealer immediately.
21