Install The Control Box - Acekare YOMPER+ User Manual

When the forward edge of the Yomper housing touches the
mounting bar, push the handle down to slide the Yomper onto
the mounting bar.
During this operation, keep the release handle open.
Once in place, check that the Yomper is properly
engaged.
Install the EasyGo control box
Install the EasyGo box on its mounting bracket :
• on your thigh
• or on the wheelchair frame
(See installation procedures page 8)
Connect the EasyGo control box to the Yomper
To turn on the control box, push the ON / OFF button (19).
During the connection phase, LEDs 1, 3 and 5 light up.
Once the connection is established, the LED strip changes to
flashing green at 1st speed (indoor mode).
9