EXCELL PRECISION CO., LTD.
12-1-36. Write Stabilization Speed Settings
This command is supported only in ADP18 or its later versions, plus AFP15 or its later versions.
Write UUID E812 handle (Hex) with the following command(s):
Calibration
Length
Sub-Command
Command
(Hex)
(Hex)
(Hex)
99
02
53
Read UUID E812 handle, which will return 99 02 7F .... (please refer to 12-1-39 Return Read & Write
Status).
Execution conditions for these
commands
12-1-37. Read Stable Speed Settings
This command is supported only in ADP18 or its later versions, plus AFP15 or its later versions.
Write UUID E812 handle (Hex) with the following command(s):
Calibration Command (Hex)
99
After the above 'Read' command set is successfully written to the UUID E812 handle, there will be
return values (Hex data) after reading the UUID E812 handle, such as the following:
99 02 13 ZZ (for descriptions regarding the ZZ return value(s), please refer to 12-1-36. Write
Stabilization Speed Settings)
If the 'Write' operation has failed, reading UUID E812 handle will instead return 99 02 7F .... (please
refer to 12-1-39 Return Read & Write Status )
Execution conditions for these
commands
12-1-38. Read Bluetooth Version
This command is supported only in ADP18 or its later versions, plus AFP15 or its later versions.
Write UUID E812 handle (Hex) with the following command(s):
Calibration Command (Hex)
99
After the above 'Read' command set is successfully written to the UUID E812 handle, there will be
return values (Hex data) after reading the UUID E812 handle, such as the following:
99 06 14 ZZ ZZ ZZ ZZ ZZ
ZZ ZZ ZZ ZZ ZZ: Firmware version
TM
Type A Data
'Write' Description
2 bytes
(Hex)
ZZ: 0-9 (default: 0)
ZZ
0: Slow stabilization
9: Fast stabilization
Calibration Mode
Executable
Length (Hex)
01
Calibration Mode
Executable
Length (Hex)
01
55
Normal Mode
Executable
Sub-Command (Hex)
13
Normal Mode
Executable
Sub-Command (Hex)
14
ZSME000000026