Write Scale Function Settings - Excell Wireless Platform Service Manual

EXCELL PRECISION CO., LTD.

12-1-28. Write Scale Function Settings

This command is supported only in ADP18 or its later versions, plus AFP15 or its later versions.
This 4F(Hex) sub-command set can be written only when Calibration Mode is enabled.
Write UUID E812 handle (Hex) with the following command(s):
Calibration Length Sub-Command
Command (Hex) (Hex)
(Hex)
99 03 4F
Execution conditions for these
commands
W1: Enable Calibration Mode via Input Password
W1 Description
1 Allow the "Enable Calibration Mode via Input Password" option; please refer to 12-2 Password
Commands 9C(Hex) for relevant password settings.
0 Disallow the "Enable Calibration Mode via Input Password" option.
N1: Negative Value Weight Display Mode
N1 Description
1 Negative value weight display range up to 1/6 of full capacity load; if the negative value is over
limit, then -OL is displayed.
0 Negative value weight display range up to -20d, if the negative value is over limit, then ------ is
displayed.
T1: Record Preceding Tare
T1 Description
1 Enable "Record Preceding Tare" option.
0 Disable "Record Preceding Tare" option.
Z1: Record Preceding Zero Point
Z1 Description
1 Enable "Record Preceding Zero Point" option.
0 Disable "Record Preceding Zero Point" option.
Read UUID E812 handle, which will return 99 02 7F .... (please refer to 12-1-39 Return Read & Write
Status).
Example :
Negative value weight display range up to 1/6 of full capacity load, "Record Preceding Tare" option
enabled, and "Record Preceding Zero Point" option enabled,
then write UUID E812 handle (Hex) data 99 03 4F 00 07 .
TM
Type A Data 2 bytes (Hex)
MSB(8bits) LSB(8bits)
0 W1 0 0 0 0 0 0 0 0 0 0 0 N1 T1 Z1
Calibration Mode
Executable
51
Normal Mode
Not executable
ZSME000000026