Viavi OneAdvisor-800 Manual page 2

OneAdvisor-800 Portable Network Tester
QUICK CARD
C O N N E C T TO F I B E R U N D E R T E S T ( F U T )
All fibers and connectors should be inspected and clean prior to connection, as described on page 1.
The OTDR may be connected to the FUT as follows:
Inspect and clean (as needed) the OTDR port
1.
on top of the test set and all fiber end faces.
If the interface to the FUT is the BBU Jumper or Trunk Cable,
2.
connect the cable to an optical coupler with the same
connector type.
Inspect and clean the FUT connected to the coupler or
3.
Optical Patch Panel (OPP).
Inspect and clean fiber end face of the Launch Cable.
4.
Connect the Launch Cable to the OTDR port.
5.
Inspect and clean the other fiber end face of the Launch Cable.
6.
Connect the Launch Cable to the coupler or OPP leading to the RRU or tower top.
7.
Figure 4: Tower Architecture with BBU Jumper
OneAdvisor-800 Portable Network Tester
Figure 5: Tower Architecture, no BBU Jumper
VIAVI//Public
Figure 3: OTDR Port Inspection
2