Xerox DocuPrint N4025 User Manual page 48

with a particular icon file set, the Xerox-Generic icon is displayed. Models are
mapped to icons based on the MIB II System Object Identifier. The Pmap.ini file
is found in the [Drive]:\[Install Directory]\ directory. The [xerox_models]
section of a sample Pmap.ini file follows.
[xerox_models]
count=5
// 4512
model1=1.3.6.1.4.1.253.8.62.1.2.1.1.1:xer_4512_normal.ico:xer_4512_green.ic
o:x er_4512_blue.ico:xer_4512_yell.ico:xer_4512_red.ico
// 4517
model2=1.3.6.1.4.1.253.8.62.1.2.2.1.1:xer_4517_normal.ico:xer_4517_green.ic
o:x er_4517_blue.ico:xer_4517_yell.ico:xer_4517_red.ico
// DocuPrint C55
model3=1.3.6.1.4.1.253.8.62.1.2.3.1.1:xer_c55_normal.ico:xer_c55_green.ico:
xer _c55_blue.ico:xer_c55_yell.ico:xer_c55_red.ico
// DocuPrint N24
model4=1.3.6.1.4.1.253.8.62.1.3.2.2.1:xer_n24_normal.ico:xer_n24_green.ico:
xer _n24_blue.ico:xer_n24_yell.ico:xer_n24_red.ico
// DocuPrint N32
model5=1.3.6.1.4.1.253.8.62.1.3.2.1.1:xer_n32_normal.ico:xer_n32_green.ico:
xer _n32_blue.ico:xer_n32_yell.ico:xer_n32_red.ico
The sample shows a [xerox_models] section with 5 model to icon definitions. Each
Format
model statement consists of a valid MIB II System Object Identifier (SysObjID)
concatenated with 5 icon file names of type ' ico' . The SysObjID and file names
are delimited by colons (' :' ). For best results each icon file should contain an icon
easily associated with the Xerox mode being represented. Each icon file should
contain icons of the following sizes: 32x32 and 43x43 pixels. Each icon file must
represent one of the status conditions reportable by PrinterMap. The file names
must be in the following order:
1. Gray (Normal) Icon (This icon is not currently used by PrinterMap but is still
required).
2. Green (Running) Icon
3. Blue (Unknown) Icon
4. Yellow (Warning) Icon
5. Red (Down) Icon
PrinterMap User Guide
32