Windows Nt 4.X Network; Introduction; Preliminary Steps - Xerox DocuPrint C55 Install Manual

Windows NT 4.X
Network

Introduction

Preliminary Steps

Q U I C K N E T W O R K
Your printer can be installed on a Windows NT network
using one of three methods:
TCP/IP protocol
DLC/LLC protocol
AppleTalk protocol
The Preliminary Steps given below must be accomplished
for all printers regardless of the protocol that is being used.
Then, the Quick Install Steps will detail the installation
based on the protocol used on your network.
1. Install Network Interface Card in printer (if not already
installed). Details are supplied in the installation kit of
the Network Interface Card.
2. Connect appropriate cabling from printer to network.
Details are in this document in the section entitled
Appendix B - Network Cable Connection.
3. Print the Print Settings page. Details are in this
document in Appendix A - Print The Print Settings
Page. Retain this page for reference.
4. Check the Print Settings page and verify that both the
desired protocol and connector are enabled.
5. Proceed to the Quick Install Steps for your network
protocol.
I N S T A L L G U I D E 21