Quick Install Steps
48
1. Connect appropriate cabling from printer to network.
Details are in this document in the section entitled
Appendix B - Network Cable Connection.
2. Print the Print Settings page. Details are in this
document in Appendix A - Print The Print Settings
Page.
3. Check the Print Settings page and verify that both
TCP/IP protocol and proper connector are enabled.
4. Go to Appendix D- Set the IP Address and perform
one of the procedures there depending on the manner
in which you wish to set your printers IP address..
5. Load print drivers and configure printer for one of the
Print Models. These drivers are available on the
Installation disk (floppy or CD-ROM) or from the
Xerox Web site (ftp.xerox.com). Details on this
installation are found in the DocuPrint C55/C55mp
Technical Information Guide .
6. Send a print job to the printer.
7. Check the print job for print quality. If print quality
problems exist, use the print quality section of the
DocuPrint C55/C55mp User Guide to correct the
problem.
8. If your print job did not print, see the Troubleshooting
section for your operating system in the DocuPrint
C55/C55mp Technical Information Guide to correct
the problem.
Q U I C K
N E T W O R K
I N S T A L L
G U I D E