Table of Contents
Advertisement
Planning for the installlation
Customer responsibilities
Site Personnel
Site Selection and
Preparation
USA/Canada
Europe
1-2
Your responsibilities prior to, during and after installation of the DocuTech 65/
DocuPrint 65 printer are:
Identify a person at your site to be the primary interface with Xerox.
Select and prepare the site for DocuTech 65/DocuPrint 65 printer installation.
The following electrical, telephone, and network services are required:
Electrical requirements
The printer requires a dedicated 115V AC 20 Amp grounded receptacle. The
power receptacle for the printer must meet the requirements stated on the
data plate on the rear of the printer.
The controller requires a dedicated 115V AC 20 Amp grounded receptacle.
The printer requires a 220-240V 13 or 10 Amp grounded receptacle. The
power receptacle for the printer must meet the requirements stated on the
data plate on the rear of the printer
The controller requires a 220-240V 13 or 10 Amp grounded receptacle.
Do not remove or modify the power cord plug. Do not use a two-prong
adapter to connect the three-prong plug to an ungrounded receptacle.
Personal injury or damage to the printer could occur.
A typical USA 20 Amp receptacle is illustrated in Figure 1-1.
Figure 1-1. USA 20 Amp receptacle
•
The power receptacle for the printer must be within easy reach of the
printer's 10 ft. (3 m) power cord from the right rear corner of the printer,
and the receptacle shall be easily accessible. Do not use an extension
cord.
•
If a Phone Share device is used an additional 115V AC 15 or 20 Amp
power receptacle is required within 6 ft. (1.8 m) of the PhoneShare device
location. (For detailed information about using a Phone Share device,
refer to the section, Telephone line requirements.
Installation Planning Guide
CAUTION
DocuTech 65/DocuPrint 65
Advertisement
Table of Contents
