Table of Contents
Advertisement
Safety notes
Printer or controller - emergency power off
Printer - ozone information
xiv
If any of the following conditions occur, turn off the equipment immediately
and disconnect the power cable from the electrical outlet. Contact an
authorized Xerox Service Representative to correct the problem:
•
The equipment emits unusual odors, or makes unusual noises.
•
The power cable is damaged or frayed.
•
A wall panel circuit breaker, fuse, or other safety device has been tripped.
•
Liquid is spilled into the equipment.
•
The equipment is exposed to water damage or flood.
•
Any part of the equipment is physically damaged.
NOTE: The only method to remove all power from the printer is to disconnect
the power cable from the electrical outlet.
This product produces ozone during normal operation. The ozone produced is
dependent on print volume and is heavier than air. Install the system in a well
ventilated room with the minimum cubic requirements size listed below.
Providing the correct environmental parameter will ensure that the
concentration levels meet safe limits.
The minimum cubic volume requirement is: 1,765 cubic feet (50 cubic
meters).
To determine if the room has the required volume to meet the ozone
requirement, the length of the room multiplied by its width and height should
be equal to or greater than the cubic volume listed above.
If you need additional information about ozone, please request the Xerox
publication Ozone (part number 600E74140) by calling 1-800-828-6571 in the
United States and Canada. In Xerox Europe countries, call the local welcome
center.
Installation Planning Guide
DocuTech 65/DocuPrint 65
Advertisement
Table of Contents
