Installation
2-10
Figure 2-10. Unlock and lock actions for the casters
•
Push the printer from the right side (the side with the swivel casters) so
that you can steer it easily.
•
At the new location, ensure that the safety requirements can be met.
•
Attempt to place the equipment in the preferred location as shown in this
chapter, in Figure 2-4. If the standard location is not possible, use one of
the other locations.
•
Ensure that the space requirements are met.
•
Re-establish all power strip, controller, modem, and printer connections.
To replace the monitor:
1. Place the monitor on the printer.
2. Tilt the front of the monitor upwards.
3. Install the ends of the front wire bracket into the front two holes. (The
wire bracket crosses over the base of the monitor.)
4. Rotate the wire bracket down into place.
5. Tilt the back of the monitor upward.
6. Install the ends of the rear wire bracket into the rear two holes. (The
wire bracket crosses over the base of the monitor.)
Installation Planning Guide
Unlock
Lock
DocuTech 65/DocuPrint 65