Installation
Preparing a location for the DocuTech 65/DocuPrint 65
Client or
DigiPath
2-2
The printer and controller components are shown in Figure 2-2. The client
workstations and the local network are provided by the customer site.
Figure 2-2. Controller and printer components
Local
Network
Modem
Controller
The controller consists of a CPU, a monitor, a keyboard, a mouse, and an
external modem. The controller may have other accessories such as an
external disk drive and a tape drive for backups.
The printer has an attachable shelf for holding any peripherals. In addition,
the printer has an internal modem.
Only one wall outlet is required to power the controller provided that you use
the power strip. The power strip has eight outlets and a ten-foot cord.
NOTE: Xerox Europe provides its own modems and power strip.
NOTE: In the USA & Canada only, if installing in a hallway or exit route,
allow a minimum of 44 inches (1118 mm) additional clearance in front of the
printer in order to meet the fire code regulations.
Figures 4 through 8 in the following section are presented in the order of
preferred placement. The dimensions assume a movable installation (carpet
no deeper than 0.25 inches or 7 mm). Additional access measurements are
shown in Table 2-2.
Installation Planning Guide
Printer
Monitor,
Keyboard, and
Mouse
DocuTech 65/DocuPrint 65