Table of Contents
Advertisement
information@ITM.com
7 Maintaining the product
7
Maintaining the product
7.1.
Changing batteries
The battery change stops the currently running
measurement program. However, stored
measurement data are preserved.
1. Read out stored measurement data, see Reading out
measurement data.
✓ If it is no longer possible to read out the saved
measurement data because the battery capacity is too
low:
> Change the batteries and read out the stored
measurement data after.
2. Place the data logger on its front.
3. Loosen the screws on the back of the data logger.
4. Remove the battery compartment cover.
5. Take the empty batteries out of the battery
compartment.
6. Insert three new batteries (type AAA). Observe the
polarity!
Only use new branded batteries. If a partially
exhausted battery is inserted, the calculation of
the battery capacity will not be performed
correctly.
In order to reach the battery life under application
temperatures below -10 °C you should use
Energizer L92 AAA-size cells.
7. Place the battery compartment cover on the battery
compartment.
8. Tighten the screws.
-
The display shows rST.
Testo-Direct
www.
53
1.800.561.8187
.ca
Advertisement
Table of Contents
