Pioneer F-Z570L Operating Instructions Manual page 113

Sound is distorted.
Sound wavers.
There's a lot of noise.
A.S.E.S. doesn't work.
(Err'' is displayed on the
cassette deck display.)
Tuner
No reception
Beat noise heard.
Noise heard.
Sound distorted.
Stereo FM broadcasts not in
stereo.
Clock and Timer
No time indication ¢ There was a power blackout.
¢ AC plug was pulled.
Timer does not work.
Music search does not work.
TROUBLESHOOTING
© There's noise on the tape you're recording from. | ® Use another tape.
¢ Recording level is too high.
© Dirty head.
© Lower the recording level.
® Clean head (see page 108).
© Head, pinch roller, capstan are dirty.
© Cassette tape isn't perfectly wound.
* Clean {see page 108).
© Rewind or fast forward to wind tape correctly.
e Use another tape.
* Raise the recording level.
* Clean head (see page 108).
* You're using a tape with a lot of noise on it.
© Recording level is too low.
¢ Head is dirty.
¢ Head is magnetized.
¢ imperfect connection of cords.
¢ Demagnetize the head with a head demagnetizer.
* Check all input/output connections and make sure
cords are firmly piugged in.
® No 4-second space between songs. ¢ Use tape with 4-second spaces between songs.
* Not enough conditions are met for A.S.E.S. © Refer to CD player operating instructions.
operation.
e Antenna not connected.
¢ Wrong radio band.
* Station not tuned in.
e¢ Amplifier input selector not set to TUNER.
¢ TV is on.
* Loop antenna is at bad position.
¢ Connect antenna correctly.
* Set to desired radio band.
¢ Tune in station.
¢ Set input selector to TUNER.
© Turn off TV or move away.
¢ Set loop antenna to better position.
e Interference from nearby fluorescent light, hair ¢ Stop using device causing interference.
dryer, or other electrical appliance.
© Not tuned in correctly. ¢ Use other controls to tune in station.
¢ Antenna in poor position. ¢ Change antenna to position that does not cause
distortion.
¢ Use external antenna.
¢ Change supplied antenna position.
© Broadcast is weak.
® Interference from other electrical devices or
multipath reception.
¢ Input signal is too strong. ¢ Switch LOCAL ON.
¢ CD player cord is too close to the antenna cord. ¢ Keep CD player cord and antenna cord as far
away from each other as possible, or switch off
power to CD player.
© Signal is too weak, antenna input is insufficient. ¢ Use an multi-element outside antenna instead.
@ MPX mode is MONO. * Cancel MONO mode with the MPX button.
¢ Set time again.
© Set time again.
¢ Set current time.
¢ Set ON and OFF times.
¢ Switch timer operation ON with the timer
selector buttons.
¢ Current time is not set.
¢ Start and/or stop time is not set.
¢ Timer is not on.
Remote Control Unit
Remote control does not work.
¢ Batteries are dead or no batteries in remote ¢ Insert new batteries.
controi unit.
© Poor angle or too great a distance from the
remote sensor window.
© There is an obstacle between you and the
remote sensor window.
¢ A fluorescent light is shining on the remote
sensor window.
¢ Use within seven meters and within a 30 degree
angle of the remote sensor window.
¢ Change your position or move the obstacle.
¢ Move so fluorescent light does not shine directly
on amplifier front panel remote sensor window.
113
<ARE1180>
En