Advertisement
Quick Links
Advertisement
Related Manuals for NCR 7357-K401
Summary of Contents for NCR 7357-K401
- Page 1 Kit Instructions PIN Pad Mount (Ingenico Lane 7000) 7357-K401 Issue A...
- Page 2 NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Software screen images are representative, and in some cases, may not match a customer’s installed software exactly.
-
Page 3: Revision Record
Revision Record Issue Date Remarks Sept 2021 First Issue... -
Page 5: Kit Contents
This publication provides procedures for installing a PIN Pad Mount for an Ingenico Lane 7000 device on an NCR FastLane SelfServ™ Checkout (7357) R6LN Plus. Note: The Ingenico Lane 7000 PIN Pad is NOT included in this kit. Hence, it must be supplied by the customer. -
Page 6: Installation Procedures
Installing the PIN Pad Mount on page 4. Installing Ingenico Lane 7000 PIN Pad on page 5. Note: The Ingenico Lane 7000 PIN Pad is not included in the 7357-K401 PIN Pad Kit. For more information, contact your NCR Customer Service Representative. - Page 7 PIN Pad Mount (Ingenico Lane 7000) Removing Existing PIN Pad Mount To remove the existing PIN Pad Mount, follow these steps: 1. Using an Allen Key, remove the screw securing the PIN Pad Mount to the PIN Pad Arm. 2. Remove the PIN Pad Mount from the PIN Pad Arm, as shown in the image below.
- Page 8 PIN Pad Mount (Ingenico Lane 7000) Installing the PIN Pad Mount To install the PIN Pad Mount (Ingenico Lane 7000), follow these steps: 1. Ensure that the existing PIN Pad mount is removed from the unit. Refer to Removing Existing PIN Pad Mount on the previous page.
- Page 9 PIN Pad Mount (Ingenico Lane 7000) Installing Ingenico Lane 7000 PIN Pad The Ingenico Lane 7000 PIN Pad is not included in the 7357-K401 PIN Pad Kit. For more information, contact your NCR Customer Service Representative. 1. Connect the PIN Pad cable to the RS232/A port of the Primary Terminal Display.
- Page 10 PIN Pad Mount (Ingenico Lane 7000) 4. Mount the PIN Pad by attaching it to the PIN Pad Mount and sliding it down, as shown in the image below. Note: The maximum vertical tilt of the PIN Pad Plate is 80° and the minimum vertical tilt is 20°.
Need help?
Do you have a question about the 7357-K401 and is the answer not in the manual?
Questions and answers