Checking The Hip Job Queue Status - Xerox 4050 Operator's Manual

PRINTING JOBS

Checking the HIP job queue status

4-8
You can review the current status of your job by entering the
following command:
HIP SHOW JOBS [parameter]
This command displays the current status of the selected jobs in
the HIP jobs queue as well as the current status of the HIP
processor. The format of the display depends on the parameter.
The following parameter options are available:
ABORTED Displays all jobs that have been aborted
ACTIVE Displays all jobs in the active state: QUEUED,
ACTIVE, OQUEUED, or PRINTING.
ALL Displays all jobs in all queues.
CANCELLED Displays all jobs that have been cancelled.
COMPLETED Displays all jobs in a completed state:
PRINTED, STORED, SEND, or ABORTED.
CONTINUE Continues a previously requested display if all
jobs in the queue were not displayed.
PAGE[n] Divides the queue up to 20 jobs, which are
ordered from the oldest completed job to
newest completed job received.
PENDING Displays all jobs in the pending state:
PENDING or RECEIVING (but not submitted
to the operator communications subsystem
(OCS)).
PRINTED Displays the jobs in the printed state:
PRINTED or TRUNCATED.
SUMMARY Displays a summary of the job queue.
Job queue display
The job queue display screen consists of two lines of header
information, up to 20 lines of jobs status information, and a
message indicating the end of the display. If there are fewer
than 20 jobs in the selected state, only that number displays. If
there are more than 20 jobs in the selected state, all jobs are not
shown, and the following message displays:
HP2145 Enter 'HIP SHOW JOBS CONTINUE' for more.
In this case, enter HIP SHOW JOBS CONTINUE to display the
additional jobs. The format of a normal display screen is shown
in figure 4-2.
XEROX 4050/4090/4450/4650 LPS OPERATOR GUIDE