Modifying Current Trays; Redefining The Preferred Trays; Assigning All System Trays To A Cluster - Xerox 4050 Operator's Manual

PRINT JOB MAINTENANCE

Modifying current trays

Redefining the preferred trays

Assigning all system trays to a cluster

5-14
3. Enter CLU and press <ENTER> to verify that your chosen
trays are removed from the current set of any clusters where
trays were previously assigned.
To set current trays without removing trays from another active
cluster:
Add /NR to the end of any CLU command you use to assign
specific trays to a cluster, for example, CLU RED 3,4/NR.
To add trays:
Enter CLU cluster-name + tray-number and press <ENTER>,
for example, CLU RED +4.
To delete trays:
Enter CLU cluster-name — tray-number and press <ENTER>,
for example, CLU RED -4 .
To define preferred trays:
Enter CLP cluster-name + tray-number and press <ENTER>,
for example, CLP RED 3. To assign more than one tray, separate
each tray number by a comma, for example, CLP RED 1,2,3.
To add trays:
Enter CLP cluster-name + tray-number and press <ENTER>,
for example, CLP RED +4.
To delete trays:
Enter CLP cluster-name - tray-number and press <ENTER>, for
example, CLP RED -4.
To turn autosize on:
Enter CLP cluster-name /A, followed by any other parameters
you need to redefine the cluster, and press <ENTER>; for
example, CLP RED/A, +4.
To turn autosize off:
Enter CLP cluster-name /-A, followed by any other parameters
you need to redefine the cluster, and press <ENTER>; for
example, CLP RED/ -A +4.
To add all feeder trays in your printing system to a cluster, key in
ALL at the end of any CLU or CLP command you use to define or
modify a cluster, for example, CLP WHITE ALL.
To delete all the system trays from a cluster, key in -ALL at the
end of the command, for example, CLU RED -ALL.
XEROX 4050/4090/4450/4650 LPS OPERATOR GUIDE