Headlamp, Position Lamp, Turn Signal Lamp, Daytime Running Light (Drl) Replacement - Hyundai TUCSON Hybrid Owner's Manual

Information
A normally functioning lamp may
flicker momentarily to stabilize the
vehicle's electrical control system.
However, if the lamp goes out after
flickering momentarily, or continues to
flicker, we recommend the system be
checked by an authorized HYUNDAI
dealer.
The position lamp may not turn on
when the position lamp switch is turned
on, but the position lamp and headlamp
switch may turn on when the headlamp
switch is turned on. This may be caused
by network failure or vehicle electrical
control system malfunction. If this
occurs, we recommend the system be
checked by an authorized HYUNDAI
dealer.
Information
The headlamp aiming should be adjusted
after an accident or after the headlamp
assembly is reinstalled.
Information
Traffic Change (For Europe)
The low beam light distribution is
asymmetric. If you go abroad to a country
with opposite traffic direction, this
asymmetric part will dazzle oncoming car
driver. To prevent dazzle, ECE regulation
demand several technical solutions (ex.
automatic change system, adhesive
sheet, down aiming). This headlamps are
designed not to dazzle opposite drivers. So,
you need not change your headlamps in a
country with opposite traffic direction.
Headlamp, position lamp, turn
signal lamp, Daytime Running
Light (DRL) replacement
Type A
(1) Headlamp (High/Low)
(2) Turn signal lamp
(3) Daytime running light/Position light
Headlamp / Turn signal lamp
1. Engage the parking brake and
disconnect the (-) battery terminal
(For plug-in hybrid vehicle) or battery
connector (For hybrid vehicle).
2. Remove wheel guard clips (under the
front bumper : 6 pieces).
09
ONX4EH090009
ONX4E091083L
9-63