Image - Dahua 41HS-W-S2 Series User Manual

Parameter
Delete
Type
Delete
Manual
Add

5.8.1.2 Image

Note
Slight difference may be found since the connected network camera may not be same model.
Here you can view device property information. The setups become valid immediately after you set. See
Figure 5-20.
Function
Click , you can delete the remote connection of the corresponding
channel.
There are two connection types. You can use the network to connect
to the camera or use the WIFI. The
camera connection mode is general; the
network camera mode is hotspot.
Select a device in the Added device list and then click Delete button,
system can disconnect the device and remove it from the Added
device list.
Click it, the interface is shown as in Figure 5-19. Here you can add
network camera manually.
You can select a channel from the dropdown list (Here only shows
disconnection channel.)
Note:

System supports manufactures such as Panasonic, Sony,
Dynacolor, Samsung, AXIS, Arecont, Dahua and Onvif standard
protocol.

If you do not input IP address here. System uses default IP
192.168.0.0 and system does not connect to this IP.

Can not add two devices at the same time. Click OK button here,
system only connect to the corresponding device of current
channel.
means current network
means current
314