Wifi Ap; General Setup; Advanced - Dahua 41HS-W-S2 Series User Manual

UDP port
HTTP port
HTTPS
RTSP port

5.8.2.3 WIFI AP

Please note this function is for some series only.
5.8.2.3.1

General Setup

The WIFI AP interface is shown as in Figure 5-29. Here you can set WIFI hotspot, so that the network
camera can use the hotspot to connect to the network.
Please refer to the following sheet for detailed information.
Parameter
SSID
Password
Seucurity
Start IP/End IP
WPS
Remote device
5.8.2.3.2

Advanced

number if necessary.
The default value is 37778. You can input the actual port
number if necessary.
The default value is 80. You can input the actual port number if
necessary.
The default value is 443. You can input the actual port number if
necessary.
The default value is 554.
Figure 5-29
Function
It is to set SSID name. You can use this name to search the
device.
It is to set SSID password. You can use this password to
connect to the network.
Select authentication from the dropdown list.
Input start IP and end IP. The NVR can allocate the IP address
in the range you specified here.
Click WPS button to enable WPS function. After the network
camera enabled this function, it can automatically connect to the
network.
In the list, you can view the network camera(s) that connected
to the NVR. It includes signal intensity, IP, MAC address, bit
rate, channel number, type, status and etc.
323