Call Ptz Function - Dahua 41HS-W-S2 Series User Manual

4.9.2.2 Call PTZ Function

Call Preset
In Figure 4-49, input preset value and then click
Call Pattern
In Figure 4-49, input pattern value and then click
call.
Call Tour
In Figure 4-49, input tour value and then click
Call Scan
In Figure 4-49, input Scan value and then click
Rotate
In Figure 4-49, click
System supports preset, tour, pattern, scan, rotate, light and etc function.
Note:

Preset, tour and pattern all need the value to be the control parameters. You can define it as y ou
require.
 You need to refer to your camera user's manual for Aux definition. In some cases, it can be used for
special process.
Aux
Click , system goes to the following interface. The options here are defined by the protocol. The aux
number is corresponding to the aux on-off button of the decoder. See Figure 4-55.
Figure 4-54
to enable the camera to rotate.
to call a preset. Click
to call a pattern. Click
to call a tour. Click again
to call a tour. Click again
again to stop call.
again to stop
to stop call.
to stop call.
197