Home Decorators Collection CELENE Use And Care Manual page 14

62 in. ceiling fan

Operation (continued)

OPERATING YOUR FAN AND REMOTE CONTROL

NOTE: The fan will store the last used speed setting for the next time it is turned on.

NOTE: You must turn the fan on prior to using the speed or time functions.

NOTE: On each start up of your ceiling fan, the fan blades will oscillate back and forth. This is a NORMAL OPERATION for DC motor ceiling

fans as they go through a calibration cycle. The fan is NOT DEFECTIVE.

Fan

button. - Press and release the

□

When turned on, the fan will begin spinning using its last speed settings. The remote control's LED bar will display the speed setting

for 5 seconds.

□

When turned off, the fan will stop spinning and the light from the remote control's LED bar will quickly darken from top to bottom.

Speed functions

button, increases the fan speed

□

Pressing and releasing the + button one time will increase the speed of the fan. Each setting increase will cause the LED bar to

illuminate slightly more, until the fan has reached the maximum speed setting, at that time the LED bar will be fully illuminated.

□

Pressing and holding the + button will increase the fan speed automatically through the speed settings and the increments will be

denoted on the LED bar. When the LED bar is fully illuminated, the fan has reached maximum speed setting.

□

Pressing the + button while in Comfort Breeze

operation.

–

button, decreases fan speed

□

Pressing and releasing the - button one time will decrease the speed of the fan. Each setting decrease will cause the LED bar to dim

slightly more, until the fan has reached the minimum speed setting. At that time the LED bar will be approximately 25% illuminated.

□

Pressing and holding the - button will decrease the fan speed automatically through the speed settings and the reductions will be

denoted on the LED bar. When the LED bar is 25% illuminated, the fan has reached the minimum speed setting.

□

Pressing the - button while in Comfort Breeze

operation.

3. Comfort Breeze

NOTE: If you are using Comfort Breeze

resume normal fan operation.

There are three Comfort Breeze

slowly from bottom to top to display the current setting.

□

Setting 1: Alternates through speeds 1 – 3, the LED bar should ll approximately 33%.

□

Setting 2: Alternates through speeds 4 – 6, the LED bar should ll approximately 66%.

□

Setting 3: Alternates through speeds 7 – 9, the LED bar should be fully illuminated.

Off

Setting 1

button to turn the fan on or off.

mode will automatically cancel the Comfort Breeze

mode, pressing the

settings. Pressing the

Setting 2

button or the fan speed buttons will cancel Comfort Breeze

button will activate the Comfort Breeze

Setting 3

mode and resume normal fan

mode and

mode and the LED bar will illuminate

Disable Comfort Breeze

Table of Contents

Show Quick Links

Hide quick links:

Need help?

Do you have a question about the CELENE and is the answer not in the manual?

Questions and answers

Kathryn M Kingsley

February 2, 2025

why won't the light turn on

1 comments:

Mr. Anderson

February 10, 2025

The CELENE ceiling fan light may not turn on due to several possible reasons:

1. Power Supply Issue – Ensure the fan is properly connected to a working power source.
2. Remote Control Battery – Check if the remote control has working AAA batteries.
3. LED Light Kit Connection – Verify that the 20-watt LED light kit is properly installed and connected.
4. Receiver Issue – Ensure the receiver is correctly installed and functioning.
5. Extension Cord Connection – Make sure the 2-pin or 3-pin extension cord is securely connected.
6. Timer Setting – If the timer function is active, it may have turned the light off automatically.
7. Faulty Components – If all connections are correct but the light still does not work, the LED light kit or receiver may be defective.

For further assistance, contact Home Decorators Collection Customer Service at 1-800-986-3460.