Maintenance; Cables; Replacing The Light - Omron F160-2 Setup Manual

Maintenance

5-2-2

Cables

Question
Is there a recommended RS-232C
cable?
5-3

Maintenance

5-3-1

Replacing the Light

F150-SL20A/SL50A
Use the following procedure to replace a Light with the F150-LT10A Light.
(The F150-LT10A cannot be connected to the older F150-S1 Camera.)
1.
2.
3.
4.
5.
Precaution
42
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
One of the following OMRON cables can be used. Select a cable that
works with the device being connected.
Connecting to a PC/AT or compatible computer (9-pin connector)
• XW2Z-200S-V (2 m)
• XW2Z-500S-V (5 m)
Connecting to a SYSMAC device (9-pin connector)
• XW2Z-200T (2 m)
• XW2Z-500T (5 m)
• The Light will gradually lose brightness over time (about 20% loss after
1,500 hours of use). Replace the Light after about 1,500 hours of use.
• Replace the Light if it is damaged or not fully functional.
Camera base
3
4
Light
Disconnect the light cable from the light connector on the back of the Cam-
era.
Remove the light cable from the slot in the camera base.
Remove the two screws securing the Light.
Remove the Light from the Camera.
Reverse steps 1 through 4 when installing the Lens and Light.
Do not disassemble the Lens. Disassembly can damage the Lens.
Answer
2
Hold this part when
removing the Cable.
1
Camera cable
Lighting connector
connector
Section 5-3