Advertisement
Available languages
Available languages
ENGLISH
purchased and where it is to be installed,
see figure 01 on page 4.
dimensions have been checked, follow the
instructions for correct installation.
If the hood does not come with the air
outlet assembled, you must assemble the
outlet as shown in picture 07 on page 8.
• To do this, mount the two half spheres
(figure 'b' in figure 07) on the body
(figure 'f' in figure 07).
• One of the parts (figure 'c' in figure 07)
must face upwards.
• Insert the shaft (figure 'd' of picture 07)
into the holes of the body (figure 'e' of
picture 07). Please note that the pictures
are only indicative and the outlet may
be different depending on the model
purchased.
Installation process
See picture 06 on page 7.
When installing the range hood, please
read the following installation instructions
carefully:
Note: Remove protective plastic from all
parts of the hood and chimney before final
installation.
• Fix the hood mounting bracket to the
wall using M5*45mm screws and
M10*45mm wall anchors.
• Align the hood body with the installed
mounting bracket and gently lower
the hood until it hangs securely on the
bracket.
• With M3*6 screws fix the air outlet
adapter. Attach a length of 150mm to
the air outlet adapter.
• Then fit the flexible tube.
• Carefully place the chimney body on
the top of the hood and use M2.9*14
screws to fix it.
• Carefully insert the second section of
the chimney and slide it into position.
Use M4*6 screws to fix it.
• To prevent the hood body from moving,
use M4.2*30 screws to fix the hood
inside.
30
Install the duct for hoods with air outlets
Once the
to the outside.
(See image 02 on page 5)
• Decide where you want to install the
duct. Consider that a short, straight
duct run will allow the hood to operate
more efficiently.
• Long ducts with bends or transitions
will reduce the performance of the
hood. As much as possible, use as few
elbows and transitions as possible.
• You must exit outside if your room does
not have one.
• Insert the conduit through the hole.
• Connect the metal conduit to the cover
and then connect it to the body of the
hood.
• Use duct tape to seal joints between
sections of duct.
8. Chimney.
9. Air vent adaptor.
10. Bell.
11. Top.
12. Elbow.
Installing the filters
(See image 09 on page 8)
• To remove the grease filter, press on
the metal locking tab. This should
disengage the filter from the hood. Then
tilt the filter down and remove it
• To install the filter, align the tabs on the
rear filter with the slots on the hood.
• Press the tab on the metal closure,
push the filter into position and release.
Make sure the filter is securely fitted
after assembly.
• To install the carbon filter, place it in
the same way as regular filters.
Note: Fit the grease filter after fitting the
charcoal filter.
Note: Charcoal filters are included with
this appliance.
To reduce the risk of fire, it is
recommended to use metal
ducting.
Advertisement
