Extraordinary Maintenance - Smeg Classic C92IPN2 Manual

pressing any button on the display;
• the symbol and the thermostat indicator
light switch off.
1. Turn the function knob to 0 to exit from the
function.
The symbol on the display remains lit until
the temperature inside the oven returns to a safe
level (and the door lock is deactivated).
2. Wait for the oven to cool down.
3. After the symbol turns off, open the door
and collect any residues that may have
been deposited inside the oven using a
damp microfibre cloth.
We recommend wearing rubber gloves
for these operations.
We recommend removing the door in
order to make the manual cleaning of
the parts that are difficult to reach
easier.
If the pyrolytic cycle gives unsatisfactory
results at minimum duration, it is
recommended to set a longer time for
subsequent cleaning cycles.
Programmed pyrolytic cycle
Just like normal cooking functions, it is
also possible to set an end time for the
Pyrolytic function.
To program a Pyrolytic cycle:
1. Turn the function knob to
appears on the display,
alternating with the duration of the Pyrolytic
cycle .
2. Press the increase
buttons to set the duration of the Pyrolytic
cycle.
3. Press the clock button
will appear on the display
alternating with the current time plus the duration
of the previously set Pyrolytic cycle.
4. Press the or
function end time.
5. Press the clock button
seconds to activate the function.
91477A753/C
.
and decrease
.
buttons to set the
or wait for a few
The current time appears on the display and the
symbol flashes to indicate that the
appliance is waiting to start the Pyrolysis cycle
and finish it at the time set by the user.

Extraordinary maintenance

Seal maintenance tips
The seal should be soft and elastic.
• To keep the seal clean, use a non-abrasive
sponge and wash with lukewarm water.
Replacing the internal light bulb
Power voltage
Danger of electrocution
• Unplug the appliance.
• Wear protective gloves.
1. Completely remove all accessories from
inside the oven.
2. Remove the rack/tray support frames.
3. Use a tool (e.g. a spoon) to remove the bulb
cover.
Take care not to scratch the enamel of
the oven cavity wall.
4. Slide out and remove the light bulb.
Do not touch the halogen light bulb
directly with your fingers, use an
insulating material.
CLEANING AND MAINTENANCE - 65