Extraordinary Maintenance - Smeg C6IPMBM2 Manual

Programmed pyrolytic cycle
Just like normal cooking functions, it is
also possible to set an end time for the
Pyrolytic function.
To program a Pyrolytic cycle:
1. Turn the function knob to
appears on the display,
alternating with the duration of the Pyrolytic
cycle .
2. Press the increase
buttons to set the duration of the Pyrolytic
cycle.
3. Press the clock button
will appear on the display
alternating with the current time plus the duration
of the previously set Pyrolytic cycle.
4. Press the or
function end time.
5. Press the clock button
seconds to activate the function.
The current time appears on the display and the
symbol flashes to indicate that the
appliance is waiting to start the Pyrolysis cycle
and finish it at the time set by the user.

Extraordinary maintenance

Seal maintenance tips
The seal should be soft and elastic.
• To keep the seal clean, use a non-abrasive
sponge and wash with lukewarm water.
Replacing the internal light bulb
Power voltage
Danger of electrocution
• Unplug the appliance.
• Wear protective gloves.
1. Completely remove all accessories from
inside the oven.
2. Remove the rack/tray support frames.
62 - CLEANING AND MAINTENANCE
.
and decrease
.
buttons to set the
or wait for a few
3. Use a tool (e.g. a spoon) to remove the bulb
cover.
Take care not to scratch the enamel of
the oven cavity wall.
4. Slide out and remove the light bulb.
Do not touch the halogen light bulb
directly with your fingers, use an
insulating material.
5. Replace the light bulb with one of the same
type (40 W).
6. Refit the cover. Ensure the moulded part of
the glass (A) is facing the door.
7. Press the cover completely down so that it
attaches perfectly to the bulb support.
91477A970/D