HP 8920A Programmer's Manual page 76

Chapter 3, HP-IB Command Guidelines
Guidelines for Operation
76
Changing Display Units.
measure used by the Test Set to display any field setting or measurement result.
For example, to change the Display Units setting for the
field from to , the following command would be used:
W dBm
MEAS:RFR:POW:DUN DBM
Display Units
DUNits Command Example
GHz
:MEAS:RFR:FREQ:ABS:DUN GHZ
MHz
:MEAS:RFR:FREQ:ABS:DUN MHZ
kHz
:MEAS:RFR:FREQ:ABS:DUN KHZ
Hz
:MEAS:RFR:FREQ:ABS:DUN HZ
ppm
:MEAS:RFR:FREQ:ERR:DUN PPM
%D
:MEAS:RFR:FREQ:ERR:DUN PCTDIFF
V
:MEAS:RFR:POW:DUN V
mV
:MEAS:RFR:POW:DUN MV
mV
:RFG:AMPL:DUN UV
dBmV
:RFG:AMPL:DUN DBUV
W
:MEAS:RFR:POW:DUN W
mW
:MEAS:RFR:POW:DUN MW
dBm
:MEAS:RFR:POW:DUN DBM
db
:MEAS:AFR:DISTN:DUN DB
%
:MEAS:AFR:DISTN:DUN PCT
s
:DEC:FGEN:GATE:DUN S
ms
:DEC:FGEN:GATE:DUN MS
Use the DUNits command to change the units-of-
measurement
TX Power