HP 8920A Programmer's Manual page 508

Rf communications test set

Hide thumbs Also See for 8920A:

Table of Contents

Chapter 8, Programming The Call Processing Subsystem

Programming The CALL BIT Screen

See "Reading the CALL BIT Screen Message Fields" on page 511

on how to read the contents of the individual messages.

:DSPecifier <'><STD/BITS><'>

:DSPecifier?

OUTPUT 714;"CALLP:DSP?"

OUTPUT 714;"CALLP:DSP 'STD'"

ENTER 714;Build_method$

See "Handoff" on page 475

This field is used to send an order type mobile station control message on the

forward voice channel to the Mobile Station. The orders available are:

Change Power to Power Level 0 - 7

Maintenance (put the mobile station in maintenance mode)

Alert (alert the mobile station)

field is a one-of-many selection field. To send an order to the mobile

station position the cursor on the

displayed. Position the cursor on the desired order and select it. Once the selection

is made a mobile station control message is sent to the Mobile Station. The

annunciator will light momentarily while the Test Set is sending the

mobile station control message.

A mobile station must be actively connected on a voice channel to the Test Set

(that is, the

annunciator lit) before attempting to send an order to a

mobile station.

for programming information.

field and select it. A list of choices is

for information