Using The Call Processing Subsystem's Remote User Interface - HP 8920A Programmer's Manual

Chapter 8, Programming The Call Processing Subsystem

Using the Call Processing Subsystem's Remote User Interface

Using the Call Processing Subsystem's Remote User Interface
NOTE: Option 004:Tone/Digital Signalling is required in an HP 8920A in order to use the Call
Connecting a Mobile Station
450
In order to use the Call Processing Subsystem's Remote User Interface, a mobile
station must be powered on, and connected to the Test Set.
Processing Subsystem. Attempting to access the Call Processing Subsystem without
Option 004 installed will generate an "Option not installed." error.
Figure 32, "Connecting a Mobile Station to the Test Set," on page 451
typical example of how to connect a mobile station to the Test Set. You may need
a special fixture to access the mobile station's antenna, audio in, and audio out
signals. These fixtures are available from the mobile station's manufacturer.
If any audio testing is to be done on the mobile station, the audio input
(microphone input) to the mobile station and the audio output (speaker output)
from the mobile station must be connected to the Test Set. If no audio testing is to
be done only the antenna needs to be connected to the Test Set.
shows a