HP 8920A Programmer's Manual page 293

Communicate Status Register Group
:STATus: COMMunicate: CONDition ?
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Condition Transition
Register Filter Registers
Figure 17 Communicate Status Register Group
The Communicate Status Register Group contains information about the Test
Set's hardware. This status group is accessed using the STATus commands. The
Communicate Status Register Group uses 16-bit registers and includes a
Condition Register, Transition Filters, an Event Register, an Enable Register, and
a Summary Message. Refer to the
for a discussion of status register operation.
246
STATus commands for the Communicate Status Register Group.
:STATus: COMMunicate
:STATus: COMMunicate: EVENt ?
Event
Register
"Status Reporting Structure Overview" on page
Figure 17
?
:PTRansition
<integer>
?
:NTRansition
<integer>
:STATus: COMMunicate: ENABle
Enable
Register
Chapter 5, Advanced Operations
Status Reporting
shows the structure and
?
<integer>
Summary Message Bit
(to bit 6 of Hardware
Status Register Group
#1 Condition Register)
ch4drw14.drw
293