Pyronix PARAGON SUPER II Installation Instructions Manual page 24

2. Check 250mA fuse on mains input
terminal block. (Below transformer)
10. Panel Waiting for Further Commands.
Day LED will flash if you have started a function but not f
inished the sequence. e.g
a. Enter @) (2) (View Log)
Panel awaiting @) to terminate function.
b. @) (4) (Change Limited User code) Awaiting codes.
Ge ® (5) (Change Master User code) Awaiting codes.
d. @) (6) (Customer Test Procedure)
Use N° keys to scroll, @) to terminate.
11. Walk Test Mode.
Enter @) @) Chime Light will flash
Set Panel to desired set mode (Full, 1, 2 or 3)
Walk Test circuits.
Enter (xX) (Xx) (x) (x) (Master Code) to exit.
12.Chime Mode.
Enter @® 1) Chime Light will stay on.
The Paragon Super will remember its last Set Mode
e (Full, 1, 2 or 3).
Any zone programmed as Entry / Exit will chime
on going open circuit.
Enter @® 4) to terminate feature.
LED will clear.
24
PARAGON
DAY
ALARM _O
TAMPER O)
PA. [e)
FIRE e)
FAULT @
(cHime OO)
{cHime 0}
PARAGON
RKP
SUPPLY
DAY >
ALARM
TAMPER O
PA. [o)
FIRE [o)
FAULT {e)
(PARAGON)
SuPPLY @
DAY C)
ALARM OO
TAMPER O
PA. [e)
FIRE {e)
PARAGON
SUPPLY @
DAY
ALARM __O
TAMPER O
PA. [e)
FIRE [e)
FAULT [e)
CHIME C)