Pyronix PARAGON SUPER II Installation Instructions Manual page 27

15 ENGINEER QUICK REFERENCE
PROGRAMMING SECTION
The information on this page is intended as a quick reference for installation engineers
who are totally conversant with the programming of the Paragon Super.
"If unsure, consult the main programming section of this manual**
functions by: (0) Except when seiting and unsetting.
1. Entering Engineer mode.
Enter @® (@) = (x) (x) (xX) (xX) (Engineer Code)
2. Exiting Engineer mode.
3, Programming Zones.
(X) then AW or to display E
FULL SET Key(®) (4) (0)
Press (@)when required Zone type
is displayed. Repeat sequence for
every zone on each set mode
4. Changing BellTime.
(New Entry/Exit Time 2-255 secs)
6. Changing Engineer Code.
Enter
CIOWO
oe