Using The Paragon Super Afterprogramming - Pyronix PARAGON SUPER II Installation Instructions Manual

then X) G00) G0 the new Engineer Code
- gives an audible acceptance tone
then )GD.0D 0 the new Engineer Code again
- gives an audible acceptance tone
If an incorrect key is entered an error tone will be given and the function ended.
9.10 Changing Event Log Reset Status
Should your customer request the ability to clear the memory log then:
Enter aa @®
9.11 Exiting Engineer Mode
Enter CIO)
then CHCHEINES)
Engineer Code
10 USING THE PARAGON SUPER AFTER
PROGRAMMING
10.1 LIMITED USER FACILITIES
10.1.1 Full Setting the panel
Enter either of the following:
CHCHENES) Limited User Code (Factory set to 5 6 7 8)
By using this method, maximum volume will be heard.
or §=@@®
10.1.2 Part setting the panel
Part set 1 (eg downstairs only armed):
A@® « ABH
Volume from extension speakers will be determined by volume pot. i.e. Reduced volume.
Part set 2 (eg upstairs only armed):
Enter @@®e@) or HAA
Volume from extension speakers will be determined by volume pot. i.e Reduced volume.
Part set 3 (eg whole house armed except garage):
16