Pyronix PARAGON SUPER II Installation Instructions Manual page 19

To clear Alarm LED
Enter CHCHENES) Master User code
or CHNCNENED) Limited User code
10.2.3 Changing Limited User Code
Enter CO}
then CNCHENES) Master User code (Factory set 1234) - 2 Bleeps
then CHCHENES) New Limited user code - 2 Bleeps
then CHNCNENCS) New Limited user code again - 2 Bleeps
The 'day' led will flash when this function is entered and an acknowledge tone will be
sounded after each code has been entered. If an incorrect key is entered an error tone
will be given and the function ended.
10.2.4 Changing Master Code
Enter aA®
then CHCNENCS) Master User code, (Factory set 1234) - 2 Bleepsthen
CHENEINC? New Master User code - 2 Bleeps
then CHCHENES) New Master User code again - 2 Bleeps
10.2.5 System Test Mode
Enter CIO)
This function performs a number of tests which are listed below.
The next test is selected by pressing any numeric key.
To exit test mode press the @® key again.
Test 1) All LED's are switched on except the fault LED.
2) The strobe is switched on.
3) The bell is switched on
4) The internal sounder is switched on
10.2.6 Walk Test Mode
Enter CIO)
When the walk test mode is enabled the 'chime' LED will flash. If the panel is then full set
or part set each active zone will cause a chime when triggered. This enables all the zone
configurations to be walk tested individually. The walk test mode is cleared when the
panel is unset. The numbers of any activated zones will be entered into the event log.
RDOC279B issue 14
19