Switching Pcs Used To Operate Usb Devices; Automatically Detecting The Input Signal - Eizo RadiForce GX560 Installation Manual

5-3. Switching PCs Used to Operate USB Devices

Switch PCs used to operate USB devices.
Attention
• Before changing the setting, remove all USB memory devices from the monitor if connected. Otherwise, data may
be lost or damaged.
• The PC used for monitor quality control purposes must be connected to
Note
• PCs that use USB devices can be switched in connection with input signal switching and mouse position by using
RadiCS / RadiCS LE.
• For details, refer to the Instructions for Use for RadiCS / RadiCS LE.
Procedure
1. Touch any switch (except
2. Select from the operation guide.
3. Select "USB-1" or "USB-2", and then select
Select the USB upstream port to which the PC used for operation is connected.

5-4. Automatically Detecting the Input Signal

This product automatically detects the connector through which a signal is input, and displays the signal
on the screen.
Procedure
1. Select "Preferences" from the Setting menu, then select
2. Select "Auto Input Detection" from "Preferences", then select
3. Select "On" or "Off", then select
Setting
On
Off
Note
• If you turn the main power off and on again, the input signal is automatically detected regardless of the
setting.
18
Chapter 5 Configuring Monitor Settings
).
.
Automatically detects the connector through which a signal is input, and displays the
signal on the screen.
If the PC that is outputting the signal displayed on the screen enters the power saving
mode or is turned off when multiple PCs are connected, any other available signal is
displayed automatically.
Displays the selected input signal regardless of whether or not it is available.
When you want to switch the input signal, see
.
.
.
.
Function
"2-2. Setting the Input Signal" (page 8).