Adjusting Brightness; Adjusting The Brightness; Adjusting The Contrast - Eizo RadiForce GX560 Installation Manual

2-4. Adjusting Brightness

Brightness levels can be adjusted and saved for each mode.
Attention
• It takes about 15 minutes for the monitor display to stabilize. After turning on the monitor power, or after the
monitor has recovered from power saving mode, wait until 15 minutes or more have passed to perform various
quality control tests, calibrations, or screen adjustment of the monitor.
Note
• Use values shown in "%" for reference.
●

Adjusting the brightness

The screen brightness is adjusted by changing the brightness of the backlight (light source from the
LCD back panel).
Setting Range
0 to 100 %
Procedure
1. Select "CAL Switch Mode" from the Setting menu, then select
2. Select "Brightness", then
3. Specify the setting using
4. Select after completing the setting.
●

Adjusting the contrast

The brightness of the screen is adjusted by varying the video signal level.
Note
• Contrast can only be adjusted in "4-Text" mode.
Setting Range
0 to 100 %
Procedure
1. Select "CAL Switch Mode" from the Setting menu, then select
2. Select "Contrast", then
3. Specify the setting using
4. Select after completing the setting.
Note
• When the contrast is set to 100 %, all the gradations are shown.
• When adjusting the monitor, it is recommended to perform brightness adjustment, which does not lose
gradation characteristics, prior to contrast adjustment.
• If the screen seems bright, the screen can also be dimmed by lowering the contrast. Lowering the contrast
reduces the amount gradation that is displayed.
10
Chapter 2 Adjusting the Screen
.
or .
.
or .
.
.