Simpson 42115 Operating Instructions Manual page 37

5 Operating Instructions
5. Then enter in the heating time for the specimen soak time and
then press the enter button on the keyboard twice. The "Test
Parameters" window will be removed.
6. After reaching the desired test temperature in the furnace and
a prepared specimen is ready, put the furnace in the up
position by using the Lift selector switch (#3 Fig. 2) located on
the front panel of the Tester.
7. A prompt on the test screen can be seen indicating the next
step of the test. It is located directly above the Real Time and
Maximum windows. It will read; Heating - Place probe under
test, position the furnace and press any key.
man-stc-42115-V15-27
Screen No. 3A
Sand Rammer 31