Sony UP-D2500 Service Manual page 46

13. Sensor data
<Contents> Displays the adjustment values (light emission level, high level, low level,
threshold level) of the four sensors automatically adjusted. (RBN_CDO
sensor, RBN_CD1 sensor, BARCODE sensor, PP_JAM sensor)
Sensor 0 (ribbon code sensor 0, light emission level value)
[Pi] [ADDR4Fh] [DATAOOh]| <EXEC>
<Data check> [P1] [ADDR26h
Sensor 1 (ribbon code sensor 0, high level value)
| Pl] [ADDR4Fh| |[DATAOIh| <EXEC>
<Data check> | Pl} |ADDR27h| |DATA**h
Sensor 2 (ribbon code sensor 0, low level value)
[P1] |ADDR4Fh| |DATA02h| <EXEC>
<Data check> [Pi] [ADDR28h] [DATA**h]
Sensor 3 (ribbon code sensor 0, threshold level value)
[Pi] [ADDR4Fh <EXEC>
<Data check> [Pil ADDR29h; |DATA**h
Sensor 4 (ribbon code sensor 1, light emission level value)
[Pi] [ADDR4Fh] <EXEC>
<Data check> ADDR2AH
Sensor 5 (ribbon code sensor 1, high level value)
ADDR4Fh]} |DATAOSh] <EXEC>
<Data check> | Pl} |ADDR2Bh} |DATA**h
Sensor 6 (ribbon code sensor 1, low level value)
Pi] [ADDR4Fh] [DATAO6h] <EXEC>
<Data check> [Pi] [ADDR2Ch] [DATA**h
Sensor 7 (ribbon code sensor 1, threshold level value)
[P1] [ADDR4Fh] [DATAO7h] <EXEC>
<Data check> [Pi] [ADDR2Dh] [DATA**h
Sensor 8 (bar code sensor, light emission level value)
[Pi] LADDR4Fh] [DATAO8h] <EXEC>
<Data check> [P1} [ADDR2Eh] [DATA**h]
Sensor 9 (bar code sensor, high level value)
LP1}] LADDR4Fh DATAO9h] <EXEC>
<Data check> [P1] [ADDR2Fh] [DATA**h]
[=llz
Elz!
ig