KYOWA WGA-680A Instruction Manual page 28

10-3. TO READ THE PRE-SET VALUES OF THE COMMANDS (BY USING THE REQUEST 2)
To read the pre-set values from the product, set the [WRITE/READ] to "ON." The product outputs the pre-set values.
Before reading the [Command data response], make sure the [Command processing response 2] is "ON."
(1) With the commands for the operation pattern (for details, see "9-1. COMMANDS FOR THE OPERATION
PATTERN"), enter the operation pattern in the [Operation pattern] of the remote register M → R. You are not
required to set the item with the commands for the general settings and commands for the control input signals.
(2) Enter the commands in the [Command No.] of the remote register M → R.
(3) Make sure the [WRITE/READ] of the remote output is ON.
(4) Change the [Command processing request 2] of the remote output. OFF [0] → ON [1]
(5) Make sure the change of the [Command processing response 2] of the remote input. OFF [0] → ON [2]
Then change the [Command processing request 2] of the remote output. ON [1] → OFF [0]
(6) The product stores the response in the [WRITE/READ response] of the remote input and in the [Command No.
response], [Command data response], and [Operation pattern response] of the remote register R → M. Check the
contents of the [Command data response].
Command processing
request 2 (RY0002)
Command processing
response 2 (RX0002)
WRITE_READ
(RY0003)
Operation pattern
(RWw000F)
Command No.
(RWw000E)
WRITE_READ response
(RX0003)
Command No. response
(RWr000E)
Command data response
(RWr000C to 000D)
Operation pattern response
(RWr000F)
10-4. CPU NORMAL OPERATION
You are able to check whether the product is working properly by using the CPU normal operation.
The product turns ON and OFF the CPU normal operation every second when the product is working properly.
CPU normal operation
(RX0006)
ON [1]
OFF [1]
ON [1]
OFF [1]
ON [1]
OFF [1]
ON [1]
OFF [0]
Approx.1 sec. Approx. 1 sec.
25
(4)
(3)
(1)
(2)
(5)
(6)
(6)
(6)
(6)