Removing And Replacing The Display Module Assembly - Motorola ROKR E2 Service Manual

Disassembly

Removing and Replacing the Display Module Assembly

36
1. Remove the SD card, battery cover, battery, SIM, side bands, rear housing,
transceiver PC board assembly, and keypad assembly as described in the
procedures.
2. Use the disassembly tool to lift the bottom edge of the display module assembly
away from the front housing.
3. Carefully lift the transceiver PC board assembly out of the front housing.
Front Housing
Figure 18. Removing the Display Module Assembly
4. To replace, align the transceiver PC board assembly to the rear housing and
then lower the transceiver PC board assembly onto the rear housing.
5. Replace the keypad assembly, transceiver PC board assembly, rear housing,
side bands, SIM, battery, battery cover, and SD card as described in the
procedures.
Display module
March 27, 2006
E2
051993o
6809497A99-O